Motor Driver

Description:Moonzite 2DM860 Stepper Motor Driver For CNC Engraving MachineSpecification:SuitableEngraving machineImpulse response frequency250KHZRated pressure24~110VRated current1.8-7.0AFine fraction2-128Feature:-New 32-bit DSP control technology, which can drive 4/6/8 line two-phase stepper motor-..

Specification:ModelWS55-140Input voltageAC110/220VOutput voltageDC 36VPower300WSpeed12000rpmTorque0.2nmMotor diameter55mmLength140mmFeatures:-The spindle tool bar is an integral rod, with ER11 3.175mm collect chuck.-The spindle motor is a brushless motor with long service life and low noise.-With a ..

Description:1) Operating voltage DC 10V-45V. DC32V switching power supply is recommended.2) high-speed optical coupling 6N137, ensure high speed without losing step.3) Toshiba's new high current, high voltage TB6600HG new original chip, there are low-pressure shut-off, overheating parking and over-c..

Features:- New three-axis motion mode for full control- Support XYZ driver, spindle inverter processing error alarm function- Large storage space, high compatibility with USB flash drive, fast reading, and reliable processing- Intelligent document checking function- Supports parameter backup and rec..

Description: Stepper Motor Driver Controller Speed Regulator Pulse Generator PWM Generation Controller without MagnetSpecifications:Type Stepper Motor Driver ControllerSize Approx. 73*51*37mmController Frequency Signal High: 5.8KHZ-127KHZ Middle: 590HZ-15.8KHZ Low: 82HZ-2.3KHZFre..

Description:1.JKD2060AC is a new generation digital 2- phase stepper motor driver, based on a 32-bit DSP processor, combination of the anti-resonance, low noise, micro-step and low temperature rise technology significantly improve the performance of the stepper motor, has low noise, small vibration,..

Features:1. The motor can be controlled arbitrarily through the button, normally open, normally closed, inching, forward, reverse, speed control, etc.2. Using imported chips, the governor runs stably and reliably.3. The potentiometer knob can change the duty cycle of the governor output, thereby cha..

Description : Pull Starter For Harbor Freight Predator Engine 212cc 6.5HP Notes :  1.Manual measuring, please allow 1 ~ 2 cm error,thank you. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. We guarantee the style i..